Total Filtration Manufacturing
OPTI-FRAME®pat. # 7,128,771 B2
INTRODUCING THE TOTAL FILTRATION LINE OF RETAINING SYSTEMS.
Today's requirements have forced engineers and building owners to improve the quality of air filtration devices from office buildings to make-up air units for sophisticated " zero " tolerance clean rooms. To keep up with the evolution process, Total Filtration Manufacturing, has gone back to basics. |
 |
"Your Filter is only as good as its' Frame ™ " A poor framing system renders air filters ineffective thus, causing them to operate at a fraction of their design capabilities. The loss of airflow causes fans to work harder to meet the demands of personal comfort and manufacturing process specifications. The end result is, more energy dollars are wasted and filter change outs increased.
Total Filtration Manufacturing has addressed these problems and will continue to do so to meet the demand of today's air quality situations.
OPTI-FRAME® PRODUCTS:
- OPTI-FRAME®/P Designed for box or single headered ASHRAE filters. Front or rear access
- OPTI-FRAME®/H Designed for HEPA filters: Gasketed or Gel Seal.
- SIZES: 24 X 24 – 12 X 24 Special sizes per request.
OPTI-FRAME® PRODUCT FEATURES:
- A proprietary, anodized, powder coated, extruded aluminum
filter retaining device.
- Tongue and groove mating.
- Knife-edge seal.
- Opti-Frame is corrosion free.
- Permanently attached Hinge-Lock Fasteners/ pat. pending for Headered Filter.
- Compression Clamp for Non Headered Box Style Filters.
- Double wrapped neoprene gasket.
- “I”Beam structural support.
OPTI-FRAME® PRODUCT ADVANTAGES:
- ZERO bypass leakage between the air filter
and frames / frame to frame.
- ZERO Flex in framing system. No more bowing will accrue.
- ZERO caulking required (between frames) to insure system integrity.
- Pre-filter replacement will not jeopardize secondary filter integrity.
- Extended life of secondary filter or HEPA.
VALUE AND LIFE CYCLE COST BENEFITS:
- Lower energy consumption.
- Fewer Maintenance intervals.
- Reduced maintenance costs.
- Decreased downtime of air handling systems.
- Reduced coil and duct cleaning expense.
The framing system shall be capable of securing 2 inch pleated pre-filters or a synthetic panel. Three inch baked powdered coated aluminum finished "I" beam support bar shall be placed downstream between the frames extruded slots, to eliminate any flexing between frames.
Opti-Frame™/H
Opti-Frame/P
"Distributor Opportunities available"
|
